||Cold Rolling Machine
||ab Lager Süddeutschland
||ex factory free on truck/conta
|rolling capacity max.
|total power requirement
|weight of the machine ca.
|2005 rebuilt and new PLC control
Max. stroke of tool slide, upper/lower 760 mm
Max. length of rack, approx. 610 mm
Length of workpiece between centres, approx. 300 mm
Max. tooth width/profile width 92 mm
Max. workpiece Ø 38 mm
Hydraulic tailstock stroke on the beam 300 mm
Module range 0.3 - 1.3
Total electrical load, approx. 20 kW - 380 V - 50 Hz
Accessories / Special Features
* Machine was modernized in Year 2005 and retrofitted with a new MITSHUBISHI
PLC Control, as well as with a new central lubrication system. The counter
bracket arm was shorted to fit the workpiece.
* Pneumatic workpiece feed system by means of a feed chute with pneumatic
inserter between the centres and ejector of parts into a run-out chute.
Machine is at present set up for workpiece size of approx. 100 x 15 mm x Module
0.75, no. of teeth 14.
* Separate hydraulic unit, approx. 300 litres, and supporting connections
between upper and lower part.
* Coolant unit, built in the machine. * Rack tools, built-in.
* Switch cabinet and control panel on the machine.
ROTO FLO machines are ideal for mass production of small gears/profiles and is
a lot more economical than gear hobbing. Workpieces are clamped between
centres and are profiled by means of synchronised rack tools, which rotate in
opposite directions. The material is displaced, and reshaped by the increasing
height of the profile in the rack tools. The profile and surface performance
is optimised in the calibrating zone of the tool. Profile run-out, which is
necessary when working with hobbing and shaping processes, is not required.
The machine stands out because of its extremely stable design. Tools have an
operating life of between 25,000 to 100,000 workpieces, also for helical gears.